how to clean ink absorber in canon mp470 printer

How to remove the remaining nozzle cleaner out of the print head?Īfter flushing the Epson print head according to our instruction there will remain a certain amount of nozzle cleaner fluid within the print head, within the printer´s ink system. Right before pulling out the kitchen towel move the print head from side to side, this swipes the nozzle plate clean once more.Īt the end put the PGI and CLI cartridges back into the printer and plug in the power cable. When You have finished the cleaning, take out the kitchen towel. The cleaner plus the dissolved cloggings come out of the nozzle plate on the print head´s bottom side and are absorbed by the paper towel. Please do not push air into the print head. Now You can push the nozzle cleaner in carefully to flush the print head and rinse out blockages. As the cleaning effect progresses You can see that the level of print head cleaner inside the plastic tube will go down. This pumping brings nozzle cleaner inside the print head and dissolves cloggings on the way to and in the nozzles itself. Once the counter is reset, you should be able to print again.Now pump the syringe´s plunger in and out carefully. Approximately all of them are pretty easy to follow, albeit contrived and not precisely discoverable on your own. Searching for your printer model and either 'ink absorber' or 'used ink tank' should provide you with a few links to check out. Population have been able to frame out how to do it, however, and there are instructions online for many printers. Unfortunately, the instructions for resetting the counter differ from printer to printer and again, as far as I can tell, are not mentioned in the manual. Until the counter reaches a distinct unknown point, that is, in which case you'll have to repeat the procedure.

However, if you haven't printed that much or you have and you just need to print something right this minute, there is a way to reset the counter and stop the error from showing up again. If you've done a lot of printing, the ink absorber may precisely be full and you might need to have it cleaned or supplanted to ensure the best printing quality.

Many ink jet printers have them, but as far as I know, only Canon Pixma printers display an error when a distinct internal counter suggests that the ink absorber may be full. This prevents smudges, so it's a good thing to have. Firstly, it might be important to note that the waste ink absorber is a small pad that sits under the cartridge's 'home' position and collects any loose ink that may be on the cartridge.

How to clean ink absorber in canon mp470 printer